E-mail: hzjesse@gmail.com
Tel: +86-571-83867628
Home > News > Content

News

Precautions For Installation Process Of Roofing Press Tile Forming Machine
Aug 25, 2017

               First, in the southern color plate is generally designed as a single layer color plate, in order to reduce the solar radiation heat into the interior of the building, in the installation of roofing panels, the roof system can be installed insulation layer. There is a very simple, cost-effective way to reduce condensation by separating the foil film on the Purlin or slats before installing the roofing plates. The air layer between the film and the housing panel will further enhance the heat insulation effect if the sagging depth of the film between the supports reaches 50~75mm.Roof Tile Machines

               Second, the side of the color plate and the end of the lap. When installing each piece of steel plate, it shall be properly placed on the front plate and clamped with the previous plate until both ends of the plate are fixed. A simple and effective method is to use a pair of clamp forceps to clip the home plate. When the steel plate is positioned vertically, at the end of the top, especially with pliers clamp the side part, so as to ensure that one end of the plate in place, and make one end of the lap is also in the correct position, thus fixing the plate, in the process of fixing, clamp should always be in the longitudinal clamping steel plate. Each plate must be completely fastened before the next plate is installed. The fixation must begin at the center of the plate, then extend to both sides, and finally to the lap of the plate. For end lap, because the roofing and wall profile board is made by the method of continuous processing, so the length of the steel plate can be limited by the conditions of transport, usually do not need to lap, steel plate length is enough to meet the needs of roofing.Roof Tile Machines

               Third, the selection of tapping screws. Fixed screws should be selected in accordance with the service life of the structure to select the fixed parts, and pay special attention to the life of the material and the life of the specified fixed parts are consistent. Note that the steel purlin thickness can not exceed the screw's self drilling ability. Currently available screws can be provided with plastic head, stainless steel top cover or coated with a special durable protective layer. In addition, in addition to the dark buckle fixed screws, the other screws are equipped with waterproof washers, and for the lighting board and special wind pressure under the situation are fitted with the corresponding special washers.Roof Tile Machines

                Four, the fixed mode of the equipment installation of the pressure tile machine has penetrating and concealed clasp type two kinds. The penetration fixed is the roof and metope color steel equipment installs the most commonly used way, namely uses the self tapping screw or the rivet to fasten the color plate on the support piece (such as Purlin), the penetrating type fixed divides into the crest fixed, the trough fixed or their combination. Dark buckle concealed type fixed is to be connected with the dark buckle color plate matching special dark buckle first fixed in support pieces (such as purlin) on the color plate of the mother rib and dark buckle center rib teeth fixed method, generally used for roofing plate installation.Roof Tile Machines